Insulator tubes
EU-TUBE are designed to meet the stringent VDE specification for insulation and they are based on silicon extrusion. Using our clip mounted EU-TUBE a higher level of electrical isolation is achieved maintaining a good thermal performance.
The semiconductor is simply inserted into the tubes which provide an all–round shroud.
Our EU-TUBE accommodate most standard packages and retain the device ready for assembly.
| Properties | EU-TUBES | Test Method |
|---|---|---|
| Thickness | 0,5 mm (wall) | – |
| Thermal Conductivity | 0.70 W/mK | MIL-I-49456A |
| Thermal Resistance per cm2 | 0.92 °C/W | – |
| Hardness | 65 +- 5 | Shore Micro |
| Tear Resistance | 6,5 kN/m | ASTM D624 |
| Tensile Strength | 1,6 MPa | ASTM D 412 |
| Dielectric Constant @1kHz | 4,9 | ASTM D150 |
| Elongation | 85 % | ASTM D150 |
| Colour | Light Grey | – |
| Temperature Range | -60° to + 180°C | – |
Features & benefits
| Remains resistant to cleaning agents, and does not support organic growth. |
| Low Thermal resistance with high voltage isolation |
| Fills air gaps between components up to 15% of the pads thickness |
| Complete encapsulation of components |
| No known deterioration over time |
| Used in conjunction with fixing spring-clips |
PERSONALIZATIONS
CERTIFICATIONS
GENERAL CATALOGUE
Euro Technologies offers a wide selection of products. Inside the general catalogue are described, each range, including its features and benefits, specifications, the available variants and possible applications.